• deutsch
    • english

Press release

15.03.2014 (Exhibition-TUBE 2014)

GERIMA sets new standards in pipe beveling machines.

With the new clamping concept GERIMA-MMP the GERIMA hand-held bevel milling machines can now also be used as portable pipe end preparation machines quickly and effectively locally.

Currently there are offered three variants:

Type Clamping system Ø-Pipe Material thickness Bevel width
MMP-S Pipe outside 76-300 mm up to 16 mm up to 20 mm
MMP-M Pipe inside 200-720 mm up to 16 mm up to 20 mm
MMP-L Pipe wall >250 mm up to 16 mm up to 20 mm

The clamping systems are tightened around the pipe or on the pipe wall. The hand bevel milling machines are connected with the clamping device and connected with a slide to the pipe edge. The bevel angle is defined by changeable milling heads with a corresponding bevel angle. The milling units are spring loaded and copy over a copying roll on the pipe wall the tube contour. Thus, a very good bevel quality is produced with accurate land width. The results are bright metallic welding bevels without heat effects.
The machines / clamping systems have been developed for use both in production as well as on the site. For disposal are electric and pneumatic milling machines.